IM RC LED R/C LIGHTS SYSTEM FOR ALL TYPES OF R/C CARS - iM124
IM RC LED R/C LIGHTS SYSTEM FOR ALL TYPES OF R/C CARS - iM124
Specs:
- Voltage Range : 5v-6v
- Size :35.5mm*31.5mm*9.5mm (L*W*H)
- Weight :7.8g (for the LED System Control Board)
- Light Cable:28AWG Silicone Wire
How to install:
- Confirm the size and installation position of LED lights, then marked.
2.Drill some LED holes on the car body. - Insert all the cables to the corresponding sockets of the LED System Control Board.
- Connect the Y-cable (CH1) long end with the LED System Control Board (CH1), two short ends with the steering servo and receiverchannel 1.
- Connect the Y cable (CH2) long end to the LED System Control Board (CH2)two short ends to the throttle servo or ESCand received channel 2.
- Stick the LED System Control Board on a suitable position of the car body.
- Fix the LED lights into the holes and make sure it is installed firmly.
- Fix all the overlong cables with the accessories.
Channel 1 Socket : Use Y-Cable to connect the Steering Servo and Receiver to LED System Control Board
Channel 2 Socket : Use Y-Cable to connect the Steering ESC or Throttle Servo and Receiver to LED System Control Board
REV 1 : RC CH1 Steering Signal Reverse
REV 2 : RC CH2 Throttle Signal Reverse
Socket 1 : Front Lower Light Socket 2 : Front Upper Light
Socket 3 : Left Signal Light Socket 4 : Right Signal Light
Socket 5 : Front Lower Light Socket 6 : Backward Light
Socket 7 : Turn ON Status/Flashing long , Tun OFF Status/Flashing while refuelling
Socket 8 : Brake Light
a . LINK : Throttle channel reversed
b . LINK : Direction channel reversed
c . LINK : Brake light ( Bright Half/ Bright Full)
UNLINK:OFF/ Bright Full